Hold the Ctrl key, select the left spline handle and the horizontal centrelineĪssign an angular dimension of 45 degrees between them Then a projected curve is generated in yellow as shown in the image below:Ĭreate a 2D Sketch on the Right Plane (Sketch 3)ĭraw a 2-point spline by using the red encircled points of the projected sketch, as shown in the image below:Ĭlick on the spline and drag both end handles one by one to activate them, as shown in the image below:ĭraw a horizontal centerline by using the endpoints of the spline, as shown in the image below: Go to the feature tree, select Sketch1 and Sketch2

Go to the property manager and select Sketch on Sketch as a projection-type Select the vertical centreline from the 2d sketch as a mirror line, as shown in the image below:Ĭlick on Close sketch to close the sketch area. Go to the property manager, click on the Mirror About input box Select the fully defined 3-point spline from the 2D sketch Go to the property manager, click on the Entities to Mirror input box Go to: Tools > Sketch Tools > Mirror or click on the Mirror Entities directly from the sketch tab This will convert the vertical solid line into the construction line Similarly, click on the mid spline handleĪnd assign a Vertical relation from the property manager, as shown in the image below:Ĭlick on the upper spline handle and assign a handle length of 85mmĬlick on the lower spline handle and assign a handle length of 80mmĬlick on the mid spline handle and assign a handle length of 250mm, as shown in the image below: Now drag the mid spline handle by holding the Alt key to maintain the tangent symmetryĪll the activated spline handles become blue, as shown in the image below:Ĭlick on the upper spline handle and choose the Horizontal relation from the property managerĬlick on the lower spline handle and choose the Horizontal relation from the property manager Select the highlighted vertical line as shown in the image below:ĭraw a horizontal centerline starting from the origin towards the rightĬlick on the centreline and assign a length of 28.55mm, as shown in the image below:ĭraw a 3-point spline by using the red encircled points of the sketch, as shown in the image below:Ĭlick on the spline and drag both end handles one by one to activate them Go to: Tools > Sketch Tools > Convert Entities Select the Top Plane from the Feature tree and click on the sketch icon

Go to: Tools > Sketch Entities > 3 Point Arcĭraw a 3-point arc by using the upper-end points of the vertical centerlinesĬlick on the arc and assign a radius of 165mm, as shown in the image below:Ĭlick on the Close sketch to close the sketch area.Ĭreate a 2D Sketch on the Top Plane (Sketch 2) Hold the Ctrl Key, select both vertical centerlinesĪssign an Equal relation from the property managerĬlick on a vertical centreline and assign a length of 4.5mm, as shown in the image below: Go to: Tools > Sketch Entities > Centerlineĭraw a small vertical centerline at both endpoints of the horizontal centerline This will convert the horizontal line into a construction line as shown in the image below: Go to: Tools > Sketch Entities > Midpoint Lineĭraw a horizontal midpoint line starting from the originĬlick on the horizontal line and assign a length of 113,5mm, as shown in the image below:Ĭlick on the fully defined horizontal midpoint line Select the Right Plane from the Feature tree and click on the sketch icon Save the file with the following name: Apple Mouse.SLDPRTĬreate a 2D Sketch on the Right Plane (Sketch 1) Open a New Part with model units set to millimeters This 3D model may not be used for any commercial, promotional, advertising or merchandising use. Disclaimer: The intellectual property depicted in this 3D model, is not affiliated with or endorsed by the original right holders.

Apple pages tutorial pdf